Camtrapper
http://www.camtrapper.com/

Bigfoot Code Expert Required
http://www.camtrapper.com/viewtopic.php?f=9&t=12358
Page 1 of 1

Author:  jonnie wilson [ Mon Jun 17, 2019 5:41 am ]
Post subject:  Bigfoot Code Expert Required

I need some help with my older Bigfoot control boards. At the moment they are set up with DXG125 cameras and I am now swapping the DXG cams for 4k cameras.

To get the 4k cameras to turn on the camera on push part of the code needs to be 2 seconds and the camera off push needs to be 3 seconds.

There are no shutter wires connected so that part of the code can stay as it is.

I have an atmel programmer so can load the but can't get my head around the part of the code that requires changing.

Any help would be greatly appreciated. Thank you

Author:  buckhuntertrailcam [ Mon Jun 17, 2019 4:37 pm ]
Post subject:  Re: Bigfoot Code Expert Required

I cannot help sorry, but let me know when you work it out l reckon l will be looking at these 4k cameras myself :awesome

Author:  johnnydeerhunter [ Tue Jun 18, 2019 2:34 am ]
Post subject:  Re: Bigfoot Code Expert Required

Can you post the code?

Author:  jonnie wilson [ Tue Jun 18, 2019 5:58 am ]
Post subject:  Re: Bigfoot Code Expert Required

johnnydeerhunter wrote:
Can you post the code?


Gary from snapshotsniper has made the changes I needed and the code is now turning the 4k camera on and off.
I can send you the code if you would like it?

Author:  johnnydeerhunter [ Wed Jun 19, 2019 2:36 am ]
Post subject:  Re: Bigfoot Code Expert Required

Not necessary if Gary took care of it for you

Author:  jonnie wilson [ Wed Jun 19, 2019 4:00 am ]
Post subject:  Re: Bigfoot Code Expert Required

johnnydeerhunter wrote:
Not necessary if Gary took care of it for you


Thanks for offering to help, I appreciate it.
Not many understand the atmel type of code anymore and although it starts off as a bas file it gets compiled to a hex file to load it to the chip. I've found out the hard way if you don't save the bas file in a couple of places when the bas is compiled to a hex flie the bas file is lost. :oops

Author:  FIREMANJIM [ Thu Jun 20, 2019 6:53 am ]
Post subject:  Re: Bigfoot Code Expert Required

The Atmel coding is very different than Picaxe. Glad you got it going. Gary, Johnny, and myself was the only folks I knew of that could do that. I am sure Jeff is fluent in Atmel as well.

Page 1 of 1 All times are
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/