Hey all. Long time no see ha ha. I'm in the process of getting my cams out. i've got one yeticam board left, and I want to figure out how to run it in night only mode. The reason for night only is to avoid false triggers from the sun shining on leaves etc. wobbling in the wind. I've got the page that shows the dip switch settings, and with 8 and 9 on it is supposed to be in night only. OK, so how do you calibrate it? It also says 5-7-9 on are for calibrating the day night settings (there is also a pot). Anyone played with this, or better yet does anyone know where i can get the instructions? If I remember right Mark had instructions on his website, but that is of course long gone. Help is appreciated. Thanks.